Model Number

DW15 Series

Features Specifications: DW15 Series Multi-purpose Circuit Breaker

Application:

DW15 Series Multi-Purpose Circuit Breaker  are rated 630 A to 4000A in current and AC50Hz 380V in voltage. The breaker is mainly used  to distribute electric energy in the power distribution network and to prevent the circuit and power equipment from overload, under voltage and short circuit .DW15- 630 can also be used in AC50hz 380V electric network to protect the motor from overload, under voltage or short circuit, or in 660V or 1140V power distribution network to offer above protections, under the normal conditions, the breaker can be used to switch the circuit and start the motor infrequently, with the current limiting characteristics, the current-limiting breaker is especially suitable for the network where large short circuit current is likely to occur.

Construction Feature:

DW15- 630 breaker are of three-dimensional arrangement type .All the contact system, instantaneous over current release ,and left and right side boards are mounted on one insulating plate. The arc-extinguishing system is mounted on the upper part. The operating mechanism can be mounted on the front face or the right side and has the "Breaking" and "Closing" indications and the manual disconnected with the tripping half axis ,is mounted on the back. The quick saturation current transformer of the current-voltage converter is put onto the lower bus bar. The under voltage time delay device, thermal relay or semiconductor release can be mounted on the lower part.

DW15-1600, 2500 and 4000 breakers are of three-dimensional arrangement type ,The frame is composed of the bottom support, side board and beam. The contact system of each phase is mounted on the bottom support and the arc-extinguishing chamber is mounted above it. The operating mechanism is at the front right of the breaker and connected with the contact system through the principal axis .The electric operating mechanism ,which is integrated with the mechanism through the square axis ,is mounted at the lower part of the breaker and used to store energy for the breaker or to close directly ,After storing energy .the release electromagnetic iron will be responsible for closing .There is an anti-bouncer mount on the top of the left side board in order to prevent the breaker against bouncing when it breaker .Various overcurrent release are mounted at the lower part of the breaker according to the different requirements. The undervoltage release,shunt release and electric operating control part are mounted on the left part. The undervoltage release and shunt release are connected with the amplifying mechanism through the tripping axis in order to reduce the tripping force for the breaker.The 12 pairs of auxiliary contacts are for users to connect the secondary loop.On the panel.there are indicatino plates of "I" and "O' (both of them are pressed down.) for closing.DW15-1000 and 1600 breakers are attached to the front manual operating handle.DW15-1000 and 1600 the manual operating handle for the overhaul.Both of them can be dismounted.

Main Technical parameter

Type	Max. of rated current A		In A	Icu kA		Ics kA		Icw kA	Arcing distance mm	Line method
				380V	660V	380V	660V
	630	T	315.400.630	70	25	30	25	12.6	280	up
		E	315.400.630
DWX15-1600	1600		630.800.1000.1600	40	-	30	-	30	350	UP or DOWN
DWX15-2500	2500		1600.2000.2500	60	-	40	-	40
DWX15-4000	4000		2500.3000.4000	80	-	50	-	60	400